To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cadOpen lugnet.cad in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / 14068
14067  |  14069
Subject: 
Re: Making parts: circles
Newsgroups: 
lugnet.cad
Date: 
Tue, 29 Aug 2006 18:41:36 GMT
Viewed: 
1311 times
  
First I want to thank you all for helping.
Second I need to clarify somethings in my original post: I'm looking to make
MLCad usable rings of wire. What I was directed to was spot on, if I had asked
for that sort of rings. That was my mistake, not anyone else's. Could you
redirect me?



Message has 1 Reply:
  RE: Making parts: circles
 
Try the Spring generator (Extras -> Generators -> Spring) and set the number of revolutions (R) and the number of bottom turns (B) both to zero -----Original Message----- From: news-gateway@lugnet.com [mailto:news-gateway...ugnet.com] On Behalf Of (...) (18 years ago, 29-Aug-06, to lugnet.cad)

Message is in Reply To:
  Making parts: circles
 
I apologize if this is a oft asked question: but where is the best place to learn how to create a non-official part? I'm specifically looking to make rings of specific inch/mm sizes. What I found on LDraw seemed to go over my head, nor can I figure (...) (18 years ago, 29-Aug-06, to lugnet.cad)

8 Messages in This Thread:



Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR