Subject:
|
RE: Making parts: circles
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Tue, 29 Aug 2006 18:53:32 GMT
|
Viewed:
|
1602 times
|
| |
|
|
Try the Spring generator (Extras -> Generators -> Spring) and set the number
of revolutions (R) and the number of bottom turns (B) both to zero
-----Original Message-----
From: news-gateway@lugnet.com [mailto:news-gateway@lugnet.com] On Behalf Of
Daniel Collis
Sent: 29 August 2006 19:42
To: lugnet.cad@lugnet.com
Subject: Re: Making parts: circles
First I want to thank you all for helping.
Second I need to clarify somethings in my original post: I'm looking to make
MLCad usable rings of wire. What I was directed to was spot on, if I had
asked
for that sort of rings. That was my mistake, not anyone else's. Could you
redirect me?
|
|
Message has 1 Reply:
 | | Re: Making parts: circles
|
| (...) This looks like it will work. Are the measurements in LDU's? I'm assuming they are, but I'd like to ask to be sure. How would I then turn it into a part sortable in MLCad? (19 years ago, 29-Aug-06, to lugnet.cad)
|
Message is in Reply To:
| | Re: Making parts: circles
|
| First I want to thank you all for helping. Second I need to clarify somethings in my original post: I'm looking to make MLCad usable rings of wire. What I was directed to was spot on, if I had asked for that sort of rings. That was my mistake, not (...) (19 years ago, 29-Aug-06, to lugnet.cad)
|
8 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
