Subject:
|
Making parts: circles
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Tue, 29 Aug 2006 00:07:08 GMT
|
Viewed:
|
1478 times
|
| |
|
|
I apologize if this is a oft asked question: but where is the best place to
learn how to create a non-official part? I'm specifically looking to make rings
of specific inch/mm sizes. What I found on LDraw seemed to go over my head, nor
can I figure out how much inch/mm on LDU is equal to. Maybe I'm looking too hard
and overlooking info. Help???
|
|
Message has 2 Replies:
 | | Re: Making parts: circles
|
| (...) I'm not sure there's one place to go for help. You should probably start by reading the LDraw file format spec on ldraw.org. After that, you pretty much need to dive in and start playing around with some files. However, I can tell you that 1 (...) (19 years ago, 29-Aug-06, to lugnet.cad)
| | | Re: Making parts: circles
|
| First I want to thank you all for helping. Second I need to clarify somethings in my original post: I'm looking to make MLCad usable rings of wire. What I was directed to was spot on, if I had asked for that sort of rings. That was my mistake, not (...) (19 years ago, 29-Aug-06, to lugnet.cad)
|
8 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
