Subject:
|
Re: Strange part/file conversion problem
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Mon, 4 Oct 2004 18:13:56 GMT
|
Viewed:
|
782 times
|
| |
|
|
In lugnet.cad, Allan Bedford wrote:
> I really hope someone can help...
>
> In a model that I built in LeoCAD, I used the 2x5 complete hinge assembly.
> (part #3149c01). However, when I ran the .dat file through LPub (then through
> L3P) then into POV-ray, I noticed that the lower plate of the hinge assembly
> seemed to have been replaced with part #3145 (the old tipper end). I thought
> this must be my mistake, so I went back into LeoCAD, but the part wasn't there.
> Stranger still, the 3145 part is not referenced in the .dat file at all. That
> means (I think) that somewhere between LPub and POV-Ray, the 3145 part is
> getting grafted into my model (and believe me, it looks way way out of place).
> Because when I look at the .pov file I do indeed see references to the 3145
> part.
>
> Any thoughts on this? Is this a bug in one of these three pieces of software?
> Is it a problem with one or more .dat files? Is there an easy work-around?
>
> Any help or hints would be greatly appreciated!
>
> Thanks in advance,
> Allan B.
Hi Allan,
Did you ever get this issue resolved? I've never heard of an issue where LPub
was adding parts, unless it is recognising a part that is synthesized by LSynth.
I'm trying to dregde up all LPub bugs so I can shoot them and and fix them
before the next release.
Kevin
|
|
Message has 2 Replies:
 | | Re: Strange part/file conversion problem
|
| I've seen this problem a few times myself. I've found there are more parts that have this problem. Up till now I've found at least three parts. 1) the bottom end of the hinge as mentioned below (hinge plate 2x5 base, 3149.dat, converts to tipper (...) (20 years ago, 5-Oct-04, to lugnet.cad)
| | | Re: Strange part/file conversion problem
|
| (...) I was able to resolve it by manually editing the .pov file once it was created. POVRay would reject the initial file, then I went in and edited out references to the wrong part, replacing them with references to the correct part. Then I simply (...) (20 years ago, 6-Oct-04, to lugnet.cad)
|
Message is in Reply To:
| | Strange part/file conversion problem
|
| I really hope someone can help... In a model that I built in LeoCAD, I used the 2x5 complete hinge assembly. (part #3149c01). However, when I ran the .dat file through LPub (then through L3P) then into POV-ray, I noticed that the lower plate of the (...) (21 years ago, 6-Jul-03, to lugnet.cad)
|
7 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
