Subject:
|
Re: A couple of questions about LPub
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Sat, 2 Aug 2003 02:40:39 GMT
|
Viewed:
|
506 times
|
| |
|
|
In lugnet.cad, Joel Hoornbeek wrote:
> Hello,
> I'm currently trying to finish up my first set of instructions, and I have a
> couple of questions about LPub.
> 1) Is there a way to only generate the images for the steps in sub-models?
> Under Building Instructions > Steps > Generate, I've tried checking only the
> "Include Sub Assemblies" box, and then selecting Generate > Instruction Images
> from the menu. It didn't seem to do anything...
Try downloading http://www.users.qwest.net/~kclague/LPub/LPub2_1_0_8_setup.exe
and using it instead, until I get a fix uploaded.
Kevin
>
> 2) Does the "Include sub-model images" check box (found under Building
> Instructions > Part Images > Content) do anything? I've tried doing test runs
> both with it checked and un-checked, and I haven't noticed any result so far.
>
> Thanks for any information or suggestions. I'm running LPub 2.2.
>
> -Joel
|
|
Message is in Reply To:
 | | A couple of questions about LPub
|
| Hello, I'm currently trying to finish up my first set of instructions, and I have a couple of questions about LPub. 1) Is there a way to only generate the images for the steps in sub-models? Under Building Instructions > Steps > Generate, I've tried (...) (21 years ago, 22-Jul-03, to lugnet.cad)
|
13 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
