 | | Strange part/file conversion problem
|
|
I really hope someone can help... In a model that I built in LeoCAD, I used the 2x5 complete hinge assembly. (part #3149c01). However, when I ran the .dat file through LPub (then through L3P) then into POV-ray, I noticed that the lower plate of the (...) (21 years ago, 6-Jul-03, to lugnet.cad)
|
| |
| | Re: Strange part/file conversion problem
|
|
(...) Hi Allan, Did you ever get this issue resolved? I've never heard of an issue where LPub was adding parts, unless it is recognising a part that is synthesized by LSynth. I'm trying to dregde up all LPub bugs so I can shoot them and and fix them (...) (20 years ago, 4-Oct-04, to lugnet.cad)
|
| |
| | Re: Strange part/file conversion problem
|
|
I've seen this problem a few times myself. I've found there are more parts that have this problem. Up till now I've found at least three parts. 1) the bottom end of the hinge as mentioned below (hinge plate 2x5 base, 3149.dat, converts to tipper (...) (20 years ago, 5-Oct-04, to lugnet.cad)
|
| |
| | Re: Strange part/file conversion problem
|
|
(...) I was able to resolve it by manually editing the .pov file once it was created. POVRay would reject the initial file, then I went in and edited out references to the wrong part, replacing them with references to the correct part. Then I simply (...) (20 years ago, 6-Oct-04, to lugnet.cad)
|
| |
| | Re: Strange part/file conversion problem
|
|
In lugnet.cad, Allan Bedford wrote: [snip] (...) If you try this again today do you still run into the same error? If so, send me files and I'll try to recreate it on my machine. (...) Kevin (20 years ago, 6-Oct-04, to lugnet.cad)
|
| |
| | Re: Strange part/file conversion problem
|
|
"Allan Bedford" <ExpertBuilder-DELET...otome.com> skrev i meddelandet news:HHMnt3.1ps6@lugnet.com... (...) through (...) assembly (...) Are you using LGEO parts? There are some parts with the wrong number there, so that could explain it. (20 years ago, 6-Oct-04, to lugnet.cad)
|
| |
| | Re: Strange part/file conversion problem
|
|
I've been working on model 8872, the forklift transport and I've again found some parts that do not convert the right way from Ldraw to LGEO: part: 6536.dat / Technic Axle Joiner Perpendicular is rotated 90 degrees part: 2905.dat / Technic Triangle (...) (20 years ago, 9-Oct-04, to lugnet.cad)
|
