| | Re: Make Small BOMs
|
|
(...) You know, I think Kevin and I were discussing this not too long ago. I vaguely remember something about using the (URL) minkowski sum> on the alpha channel of the png files. But I don't remember exactly what for. Anyhow, there's a nifty applet (...) (19 years ago, 24-May-05, to lugnet.cad, FTX)
|
|
| | Re: Make Small BOMs
|
|
(...) <snip> (...) That's essentially what my algorithm does but I give the bias to whichever side will make the biggest new area rather than basing it on a specific preference. (...) Although there's no particular reason for it to happen, my (...) (19 years ago, 23-May-05, to lugnet.cad)
|
|
| | Re: LPub
|
|
(...) Yes, I got your mpd-file. In the case of splitting up the MPD into individual files (Save As LDRAW files), there was an LPub bug. In the case where LPub extracts the files to LPub\Ldraw I found nothing wrong yet. (...) The only environment (...) (19 years ago, 23-May-05, to lugnet.cad)
|
|
| | Znap parts
|
|
When do I see Znap parts on the parts tracker? It seems to me to be good for construction of big technical buildings like bridges. cu MikeHeide (19 years ago, 23-May-05, to lugnet.cad)
|
|
| | Re: LPub
|
|
Kevin L. Clague schrieb: (...) Hi Kevin, hope you get already my mpd-file. I think that the problem is not the file, but your code. If I put the file in the models folder the problem is not there. So the problem has to be 1) in the creation code of (...) (19 years ago, 23-May-05, to lugnet.cad)
|
|
| | Re: New parts by me..
|
|
Thomas Burger schrieb: (...) Yes, please upload cu MikeHeide (19 years ago, 23-May-05, to lugnet.cad)
|
|
| | Re: Transparent parts in LDView using LPub
|
|
(...) It's not a good solution, but if you turn off transparency sorting, the problem will probably go away. (The reason it's not a good solution is that other artifacts will likely be visible then.) I'll investigate. I don't see this in the UI (...) (19 years ago, 23-May-05, to lugnet.cad.ray)
|
|
| | Transparent parts in LDView using LPub
|
|
Hi all, Is there some way to get this (URL) better? I mean without the triangles. I think this question has already been answered, but I cannot seem to find the right post... Thanks. Jaco. (19 years ago, 23-May-05, to lugnet.cad.ray)
|
|
| | Anyone else seen jLug?
|
|
No, I don't mean the (URL) forum for AFOLS>, I mean the (URL) Java-based LEGO model editor>! I just downloaded it, and although slow on my machine (what isn't!!) it seems to run OK. Loads and saves DAT & LDR files, looks like no MPD support, (...) (19 years ago, 23-May-05, to lugnet.cad, FTX)
|
|
| | Re: New parts by me..
|
|
(...) well the train window is ready for pt submit, but the boat window isnt.. i made it 1 plate to high and had to shrink it to fit.. i only needed it for cad.. ive actually done other parts, such as those seen here: (URL) the base plate from here (...) (19 years ago, 22-May-05, to lugnet.cad)
|