 | | Re: Sorting by line
|
|
(...) That's what I did in the map I did but if you can make them "sticky" meaning that they stay by some other line in the file (the one that they precede?) that might be interesting. Might not be useful though. (...) Those are good, Also if you (...) (20 years ago, 14-Feb-05, to lugnet.cad.dev)
|
| |
| | Re: Sorting by line
|
|
(...) Should this be a dialog that pops up when sorting in initiated, in the program options, or something else? The current method I'm using moves all type 0 lines to the top. Should I simply delete them instead? Also, what about sort order? Should (...) (20 years ago, 14-Feb-05, to lugnet.cad.dev)
|
| |
| | Re: Sorting by line
|
|
(...) centroid was my first thought but leave it to the user would be better w. (20 years ago, 14-Feb-05, to lugnet.cad.dev)
|
| |
| | Re: Sorting by line
|
|
(...) I would tend to lean toward the centroid, but perhaps it would be best to be user configurable. --Travis (20 years ago, 14-Feb-05, to lugnet.cad.dev)
|
| |
| | Sorting by line
|
|
I'm implementing sorting in LDDP. Here's my question: Say I'm sorting by position using Y. When sorting linetypes 2-5 should I take the maximum Y, the minimum Y, the Y value of center of the triangle/quad/line, or something else entirely? -Orion (20 years ago, 14-Feb-05, to lugnet.cad.dev)
|
| |
| | Re: ? for the MLCAD Guru's
|
|
Mark, My recommendation is to use buffer exchange. Buffer exchange lets you take the current state of the model, and put a copy of it in a buffer. Later you can restore the buffer, and erase any changes made between the store and the retrieve. (...) (20 years ago, 13-Feb-05, to lugnet.cad.mlcad)
|
| |
| | ? for the MLCAD Guru's
|
|
Is there a way to make a part "disappear" while in step mode and "reappear" later? Here's what I'm trying to do: <step> Part01 is shown <many steps later> Part01 "disappears" to allow viewing of another part's placement which otherwise would be (...) (20 years ago, 13-Feb-05, to lugnet.cad.mlcad)
|
| |
| | Re: Fixed LGEO parts
|
|
(...) (URL) intended to be a full, open licenced, and community supported replacement for LGEO. Note this not to take away from Lutz who did a great job with LGEO but he hasn't updated in years while the number of LDraw parts has skyrocketed. You (...) (20 years ago, 12-Feb-05, to lugnet.cad.ray)
|
| |
| | Re: Classic space LDraw model repository
|
|
Fantastic !! This is my favorite Brickshelf gallery, and it surely would deserve a permanent link from www.ldraw.org ! Keep on your great work ! D. (20 years ago, 12-Feb-05, to lugnet.cad, lugnet.space)
|
| |
| | Re: Fixed LGEO parts
|
|
(...) Yes the axleholes were only half the brickwidth, so they didn't make it to surface of the back side. lg_32140.inc Technic Liftarm 2 x 4 L-Shape lg_6629.inc Technic Liftarm 1 x 9 Bent had the same problem. I've updated (URL) with all three. (...) (20 years ago, 12-Feb-05, to lugnet.cad.ray)
|
