 | | Need partnumbers and some partnames
|
|
Now the parts update 2003-03 is released, I started to make some parts I have already created ready for upload to the parts tracker. I need partnumbers for the following parts. I also want to know if the partnames are correct. * Technic Brick 1 x 2 (...) (21 years ago, 29-Dec-03, to lugnet.cad.dev)
|
| |
| | Re: BFC And Mirroring (LDS)
|
|
(...) Thanks Steve. :) (21 years ago, 29-Dec-03, to lugnet.cad.dev)
|
| |
| | Re: primer/tutorial on BFC?
|
|
(...) OK - it's not a technique I use, but in an email conversation recently somebody convinced me that inverting the matrix would switch the winding. Now that I test it again I found I was mistaken. Chris (21 years ago, 28-Dec-03, to lugnet.cad.dev)
|
| |
| | Re: Keyword in description missing
|
|
(...) OK - I'll make it so. Chris (21 years ago, 28-Dec-03, to lugnet.cad.dat.parts)
|
| |
| | Re: BFC And Mirroring (LDS)
|
|
In lugnet.cad.dev, Tore Eriksson wrote: [snip] (...) Yes. Steve (21 years ago, 28-Dec-03, to lugnet.cad.dev)
|
| |
| | Re: primer/tutorial on BFC?
|
|
In lugnet.cad.dev, Chris Dee wrote: [snip] Thanks for writing this up, Chris! Your explanation was very good in all respects except for one small point: (...) Actually, negating the transformation matrix should not invert any object; and even if it (...) (21 years ago, 28-Dec-03, to lugnet.cad.dev)
|
| |
| | Re: Keyword in description missing
|
|
(...) I feel pretty strongly that the title for all patterned parts should end in the word Pattern. I would consider this enough of a reason to make the change. (...) Steve (21 years ago, 28-Dec-03, to lugnet.cad.dat.parts)
|
| |
| | Possible part number for Hailfire Droid wheels?
|
|
The inner carton in set 4481 (Hailfire Droid) which contains the two giant wheels bears a small sticker with two numbers 47742 and 4204700. Is it possible that 47742 is the part number for the wheel (and 4204700 a number for combo package) ? It was (...) (21 years ago, 27-Dec-03, to lugnet.cad)
|
| |
| | Re: primer/tutorial on BFC?
|
|
(...) I think ease or difficulty depends on which tools you use to author parts. I use LDAO as the editor with L3Lab for preview and find it reasonably easy. Others may wish to comment with reference to their favourite tools. To BFC an existing DAT (...) (21 years ago, 27-Dec-03, to lugnet.cad.dev)
|
| |
| | BFC And Mirroring (LDS)
|
|
As I am into a major revision of the LDS Compiler, I have stumbled upon the problem with mirroring and extruding and their effect on BFD winding. My question is: Is it correct to rewind the points if a polygon has been mirrored an odd number of (...) (21 years ago, 27-Dec-03, to lugnet.cad.dev)
|
