Subject:
|
Re: Proportions for a 2001 Monolith in LEGO?
|
Newsgroups:
|
lugnet.build
|
Date:
|
Mon, 26 Jan 2004 02:22:45 GMT
|
Viewed:
|
818 times
|
| |
|
|
In lugnet.build, Matthew Jeffery wrote:
| |
I am of the belief that you guys are nuts! :) (No offence intended)
the simplest solution, as far as I can work out, is to build it for the most
part studs up, and use some 2 stud long technic axles inside the inner tubes
of the brick, both ways:
|
Congratulations, you win...um, you win...well, you don’t win anything, actually,
but that pretty efficiently takes care of most of this discussion (though it
would probably look better in 2x8 bricks). I’d thought about using pins to do
the same thing, but the ridge around the middle would prevent the bricks from
pushing completely together. I never even considered using axles...
Anyways, if you don’t have the old variety, one way to get around it would be to
put in a section of 2x8 TECHNIC plates and stick longer axles through the holes
in the middle.
|
|
Message is in Reply To:
 | | Re: Proportions for a 2001 Monolith in LEGO?
|
| <snip> (...) I am of the belief that you guys are nuts! :) (No offence intended) the simplest solution, as far as I can work out, is to build it for the most part studs up, and use some 2 stud long technic axles inside the inner tubes of the brick, (...) (21 years ago, 25-Jan-04, to lugnet.build, FTX)
|
20 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
