| | HandyBoard newsgroup...
|
|
I'd like to know how to get on the handy board newsgroup and also would like any ordering information on the Microprocessor 68HC11. Thanks, Mr John Anderson (27 years ago, 15-Jul-97, to lugnet.robotics.handyboard)
|
|
| | Mars Rover
|
|
Can anyone direct me to a good site where i can get info about the sensors, behaviors and other mobile robotic aspects of the mars rover... Thanks Sriram (27 years ago, 15-Jul-97, to lugnet.robotics.handyboard)
|
|
| | [Fwd: Announce: ColdFire Discussion List]
|
|
The coldfire kit looks like a good deal. Does anyone know what the pSOS, C compiler and debugger cost if you wish to purchase them after the 60 day demo period? (...) (27 years ago, 15-Jul-97, to lugnet.robotics.handyboard)
|
|
| | [Fwd: Announce: ColdFire Discussion List]
|
|
For those of you who haven't heard, Motorola is currently offering a deal on the ColdFire Evaluation board. The board comes with 4Mbytes of DRAM (in the form of a 1Mx32 SIMM) and 256KB of Flash ROM (two 128KB Flash ROMS), two serial ports, a (...) (27 years ago, 15-Jul-97, to lugnet.robotics.handyboard)
|
|
| | Re:rug warrior memory
|
|
Mike, My HB does similar things and to fix it I just turn the board of and then on again without leaving ic(shareware v) and it generally sychronises. Joe Martin Email:joema@mpx.com.au ---...--- (...) (27 years ago, 15-Jul-97, to lugnet.robotics.handyboard)
|
|
| | 68hc12?
|
|
I'm currently assemblying a handyboard and came across some literature for Motorola's 68HC12 microcontroller. The one thing that attracted me to it is its built in memory-mapping capabilities. Do people generally find the handboard's 32K limiting? (...) (27 years ago, 14-Jul-97, to lugnet.robotics.handyboard)
|
|
| | rug warrior memory
|
|
config should be set to 0x0c, not 0x0d. let us know if that works. -fred (27 years ago, 14-Jul-97, to lugnet.robotics.handyboard)
|
|
| | rug warrior memory
|
|
I think i am still having trouble with the memory on my home brewed rug warrior board. I am using a 68hc11a1fn chip. I completely rewired it and i am positive it is wired correctly, however i still cant get the pcode to run. It will downlod (...) (27 years ago, 13-Jul-97, to lugnet.robotics.handyboard)
|
|
| | rug warrior board
|
|
I am trying to wire up a rug warrior board, and i think i have thecomputational hardware all set up correctly. I have been over my wiring as best as i can and cant fina a problem. Here is what it is doing. I can download the p code interperter ok, (...) (27 years ago, 11-Jul-97, to lugnet.robotics.handyboard)
|
|
| | enable_cheesy_encoders
|
|
I've tried the enable_cheesy_encoders and it doesn't seem to work for me either. What I get is 0 for the portX_shaft_count all the time. Is this what you're getting? I've looked at the code but I couldn't see why it wouldn't work. Were you or anyone (...) (27 years ago, 11-Jul-97, to lugnet.robotics.handyboard)
|