Subject:
|
rug warrior memory
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sun, 13 Jul 1997 19:49:32 GMT
|
Original-From:
|
Mike Downey <mdowney@eng+StopSpam+.ua.edu>
|
Reply-To:
|
MDOWNEY@ENGnomorespam.UA.EDU
|
Viewed:
|
874 times
|
| |
| |
I think i am still having trouble with the memory on my home brewed rug
warrior board. I am using a 68hc11a1fn chip. I completely rewired it and
i am positive it is wired correctly, however i still cant get the pcode
to run. It will downlod ocrrectly (I set the config register to 0x0d)
and say it is ready to run. When i run ic, it says it cant sync with the
board.
When i called to order the memory a while back, they said they were out
of the 62256 but had a 52256. They guy assured me the only difference
was that the 52256 was faster and should work fine. I cant find a data
sheet on it anywhere (it is made by mitsubishi). Can you guys help me
find one?
Do you think this might be my problem? I am not sure what to try next.
Thanks
Mike
--
,,,
(o o)
==========================oOO==(_)==OOo==========================
F U cn rd dis U mst uz Unix.
http://www.eng.ua.edu/~mdowney
Mike Downey mdowney@eng.ua.edu
http://www.cw.ua.edu/ .oooO Oooo. http://www.bamamag.com
==========================( )==( )===========================
\ ( ) /
\_) (_/
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|