| | Rug Warrior Program in Mobile Robotics Book
|
|
I finally have my HB completed and yesterday I located the Mobile Robotics book at the University of Arkansas bookstore. Anyway what I want to know is can I load the rug warrior program that is in the back of the book as is and make it work. Are (...) (28 years ago, 28-Jan-97, to lugnet.robotics.handyboard)
|
|
| | 68HC11
|
|
Howdy, I'm looking for a supplier of the 6811 that does not have a minimum order requirement. I was talking to Motorola direct and they had a minimum of 23 pices on theMC 68HC11A1FN. It's true that I'd like to have that many HB entities but I think (...) (28 years ago, 28-Jan-97, to lugnet.robotics.handyboard)
|
|
| | High power motor drivers
|
|
I need to drive two motors from the handy board and I need a little help building a driver circuit. The motors are 12v ~1.5A motors that are to be run in both directions. I want to use the motor outputs on the handyboard as the control signal to the (...) (28 years ago, 28-Jan-97, to lugnet.robotics.handyboard)
|
|
| | Re: Power Supply
|
|
The FAQ is at the Home Page. (...) (28 years ago, 28-Jan-97, to lugnet.robotics.handyboard)
|
|
| | What a day.
|
|
Well I wanted to demo my new robot it was cool, but the day did not turn out to well. I think I switched the phone cables. When I tried to connect my interface board with the HB, it would not run IC. I then tried to download a new PCODE_HR.S19, but (...) (28 years ago, 28-Jan-97, to lugnet.robotics.handyboard)
|
|
| | (no subject)
|
|
1. Is it possible to expand the 32K RAM of the Handy Board? If so, how? 2. We will be using two shaft encoders (HEDS5500 from Hewlett-Packard) for our project. How can we interface the shaft encoders to the Handy Board? What inputs do we use? Does (...) (28 years ago, 28-Jan-97, to lugnet.robotics.handyboard)
|
|
| | Power Supply
|
|
I'm using the 1.2 volt NiCad's wired in series to give me 9.6 volts. If I want to get rid of one or two of the batteries, will the handyboard still run at 7.2 or 6.0 volts ? What is the minimum voltage that the handyboard will run on, 5V ? I dont (...) (28 years ago, 27-Jan-97, to lugnet.robotics.handyboard)
|
|
| | Unsubscribe
|
|
Please drop me from the list. I can't handle the volume. Ken Owen (28 years ago, 27-Jan-97, to lugnet.robotics.handyboard)
|
|
| | as11
|
|
Can anyone tell me how to get the Motorola freeware assembler for the HC11, to run on a PC? Thanks Richard Whitehead (28 years ago, 27-Jan-97, to lugnet.robotics.handyboard)
|
|
| | Re: Mobile Robots book
|
|
I recieved my copy in a special deal from a book club that catered to electronics enthusiasts. It was a kind of Book-of-the-month club. The name escapes me at the moment. Anyway, you got to choose 3 books for like $5. Then you just had to buy one (...) (28 years ago, 27-Jan-97, to lugnet.robotics.handyboard)
|