 | | Re: Discussion of Train Table Sizes —Philippe Label
|
| | | Hello Thomas, Thank you for your interesting update on this everlasting point of table standardization. We are also seriously considering the standardization of tables for multi-participant presentations. Although it seems quite improbable that a (...) (20 years ago, 12-Dec-04, to lugnet.trains.org, FTX)
|
| | | |
| | | | | Re: Discussion of Train Table Sizes —Larry Pieniazek
|
| | | | | In lugnet.trains.org, Philippe Label wrote: (snip) A quick note... If you go with 30 inches EXACTLY, your tables will be just a smidgeon too small to hold a 4x4 baseplate since they are not exactly 15 inches but rather just a little over. We went (...) (20 years ago, 12-Dec-04, to lugnet.trains.org, FTX)
|
| | | | | |
| | | | | | | Re: Discussion of Train Table Sizes —Larry Pieniazek
|
| | | | | | | (...) That's a typo. I mean 4 (nominal 15") 48 stud square baseplates, a 2x2 square of them, (or a 3x3 square of (nominal 10") 32 stud square baseplates)... Sorry for any confusion! (20 years ago, 12-Dec-04, to lugnet.trains.org, FTX)
|
| | | | | | | |
| | | | | | | Re: Discussion of Train Table Sizes —Ludo Soete
|
| | | | | | (...) Hi all, I did use the measure of 30 and 7/32nds, with gives us 767,55625 millimeters, and rounded them up to 768mm. This is indeed a bit too much, because we got also problems with bridges (96 studs long) mounted on a table 30 bricks below the (...) (20 years ago, 14-Dec-04, to lugnet.trains.org)
|
| | | | | | |
| | | | | | | | Re: Discussion of Train Table Sizes —William R. Ward
|
| | | | | | (...) I'm surprised you would use inches as your base measurement, since you are based in Europe. Why didn't you just use the simple formula 1 stud = 8 mm? (20 years ago, 16-Dec-04, to lugnet.trains.org)
|
| | | | | | |
| | | | | Train Table Height [was: Discussion of Train Table Sizes] —Thomas Garrison
|
| | | | (...) To the best of my knowledge, no. General model railroading practice seems to be 36 inches. Some LTCs use this height. Most clubs of which I know use 30 inches (this is the nominal height of banquet tables, and easily achieved with standard (...) (20 years ago, 15-Dec-04, to lugnet.trains.org)
|
| | | | |
