Subject:
|
Re: Transitional piece construction
|
Newsgroups:
|
lugnet.trains.org
|
Date:
|
Wed, 25 Aug 1999 15:59:39 GMT
|
Viewed:
|
800 times
|
| |
|
|
In lugnet.trains.org, Larry Pieniazek writes:
> Carbon 60 wrote:
> > How would a purist make the section self-isolating,
> > sliding track, RCX?
>
> I'm not 100% pure. So I would use sticker edges between rail joints to
> insulate. Or just mount the track one stud apart, that makes a fine gap.
that will works but you will need 2 joint like that because when to train motor
will cross over the joints both front and rear wheels are connected and will
short-ciruit the 2 modules
(also bad ascii art)
A B
====~====~====
^ ^
| |
| |
joint with sticker (scoth tape)
use 2 lego switch like part 6551 to feed the insulated track section between
the 2 modules (one feed by side A the other by side B), turn them off at all
time except when you what to cross a train over then turn them on alternatively
one at a time to make the train cross the insulated section. But make sure not
to turn them on both at the same time. Also make sure when one switch is one
that the train will not go ever the other section. You can also go check
Matthew Bate Train Depot site for more info.
(http://ourworld.compuserve.com/homepages/train_depot/)
Martin
> >
> > Another way would be to use points/switches either end but that would
> > restrict the placement of the module - it would have to be on a corner
> > on each groups layouts.
>
> Why? You just need two switches back to back, like so (bad ascii art)
>
> A2---\
> A----------+---+---------B
> \--------B2
>
> When you align both switches to A2 and B2 respectively, A-B are no
> longer electrically connected at all.
> --
> Larry Pieniazek larryp@novera.com http://my.voyager.net/lar
> - - - Web Application Integration! http://www.novera.com
> fund Lugnet(tm): http://www.ebates.com/ Member ref: lar, 1/2 $$ to
> lugnet.
>
> NOTE: I have left CTP, effective 18 June 99, and my CTP email
> will not work after then. Please switch to my Novera ID.
|
|
Message has 1 Reply:
 | | Re: Transitional piece construction
|
| (...) Hi again, had a better idea you still need to make to insulated joint but at each joint you only need to put scoth tape on one side of the track: see the other ascii art trial | | A | | | = -> insulation | | | | | | middle section | | = |-> (...) (25 years ago, 25-Aug-99, to lugnet.trains.org)
|
Message is in Reply To:
| | Re: Transitional piece construction
|
| (...) I'm not 100% pure. So I would use sticker edges between rail joints to insulate. Or just mount the track one stud apart, that makes a fine gap. (...) Why? You just need two switches back to back, like so (bad ascii art) A2---\ (...) (25 years ago, 24-Aug-99, to lugnet.trains.org)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
