 | | Re: Transitional piece construction —Larry Pieniazek
|
| | | (...) I'm not 100% pure. So I would use sticker edges between rail joints to insulate. Or just mount the track one stud apart, that makes a fine gap. (...) Why? You just need two switches back to back, like so (bad ascii art) A2---\ (...) (25 years ago, 24-Aug-99, to lugnet.trains.org)
|
| | | |
| | | | | Re: Transitional piece construction —Martin Legault
|
| | | | (...) that will works but you will need 2 joint like that because when to train motor will cross over the joints both front and rear wheels are connected and will short-ciruit the 2 modules (also bad ascii art) A B ====~====~==== ^ ^ | | | | joint (...) (25 years ago, 25-Aug-99, to lugnet.trains.org)
|
| | | | |
| | | | | | Re: Transitional piece construction —Martin Legault
|
| | | | (...) Hi again, had a better idea you still need to make to insulated joint but at each joint you only need to put scoth tape on one side of the track: see the other ascii art trial | | A | | | = -> insulation | | | | | | middle section | | = |-> (...) (25 years ago, 25-Aug-99, to lugnet.trains.org)
|
| | | | |
