Subject:
|
idea for quarter panel use (new)
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Sun, 25 Feb 2001 18:04:56 GMT
|
Viewed:
|
485 times
|
| |
|
|
For a couple weeks now, I've been working a model of the following
tear-drop center-flow hopper:
http://gelwood.railfan.net/frt/el20004.jpg
I haven't had much success with a model of it yet, so I thought I would
throw it out to you all and maybe we could come up with some ideas.
I believe that the squared off section of the fram should be six studs
wide to keep in proper proportion with the 8wide tank.
Any ideas?
-chris
|
|
Message has 1 Reply:
 | | Re: idea for quarter panel use (new)
|
| (...) This may not relate, but you gould also use 4 quarter panels to make a larger water tank for an older building. You could use a few plates for the framing (build it from scratch). then maybe some slopes for the hatches? Josh (24 years ago, 25-Feb-01, to lugnet.trains)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
