Subject:
|
Layout Help
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Tue, 7 Nov 2000 01:11:21 GMT
|
Viewed:
|
513 times
|
| |
|
|
Hi all,
I have a room in my basement that is 9 x 14. There is a door in the bottom
left. The only entrance! I would like to have a walkway into the room and be
able to reach the whole layout from above. This is Version 1.
http://www.brickshelf.com/cgi-bin/gallery.cgi?i=19574
Any help whould be apprciated. I have 2 cross tracks but was unable to place
them. I also have a coal facilty that sits above the 4 tracks on the right
side.
At each end there is a peace of rail that curves. I was going to attempt to
have that go under the layout where I would keep all the trains.
Thanks
Jim
|
|
Message has 3 Replies:
 | | Re: Layout Help
|
| (...) Hmm...you don't have enough room to manage double ended access. (at least, not with that layout). On a curve, Matt gives 1 plate/lenght as recommended max grade. If possible, I would stick to that. My max. grade is more like 1.25 (...) (24 years ago, 7-Nov-00, to lugnet.trains)
| | | Re: Layout Help
|
| jrosco wrote in message ... (...) be (...) place (...) Were you planning on having any buildings on this layout, Jim? There's not much space for them between the roads and tracks. The two switches in the top right and top left look as though they (...) (24 years ago, 7-Nov-00, to lugnet.trains)
| | | Re: Layout Help
|
| (...) I wouldn't give up on going under the layout but you will need to start your down slope a lot sooner. I am planning a second level for my ~11' x 11' layout and built a test sloped section to see if the equipment could handle it. Keep in mind (...) (24 years ago, 13-Nov-00, to lugnet.trains)
|
4 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
