 | | Re: ex-MILW Soo Line GP40
|
|
(...) Matt- This is awesome! I looked at your Flickr pictures and there is just so much SNOT on this MOC. It's dripping! I love the way you captured the worn paint and the cab design rocks. Excellent work! -Dave ToT-LUG (16 years ago, 2-Jan-09, to lugnet.trains)
|
| |
| | Ballast Studies & Guides for LEGO 9V Train Track
|
|
After months of planning this, I finally had some time to get my ballast studies completed for LEGO 9V straight, curve, and switch track. I have posted pictures along with LDraw generated guide sheets at my (URL) MOCPages Page>. Many thanks go out (...) (16 years ago, 1-Jan-09, to lugnet.trains, FTX)
|
| |
| | ex-MILW Soo Line GP40
|
|
Sometime in late July while on a long, 6 hour drive to Pennsylvania I started playing around with ideas to build a (URL) "Soo Bandit" GP40> in CAD to pass the time. I chose the bandit scheme because of the challenge presented by its weathered patch (...) (16 years ago, 31-Dec-08, to lugnet.trains, FTX)
|
| |
| | Re: Reshaping 4.5v track
|
|
(...) I have been using 2x4 plates, turntables, and a solid base-brick and a hair-drier with limited success. It would seem the plastic is a bit brittle from years of disuse. (16 years ago, 28-Dec-08, to lugnet.trains)
|
| |
| | Re: Hopper car model
|
|
I think ldraw.org has been toying around with the idea of hosting a model repository. I'm not sure if this applies only to official sets, or MOCs as well. It's also a long way away from going live. -Mike (16 years ago, 28-Dec-08, to lugnet.trains, FTX)
|
| |
| | Re: Beating up, kicking, and verbally abusing an old dead rotted horse...
|
|
(...) (URL) (16 years ago, 24-Dec-08, to lugnet.trains, lugnet.general)
|
| |
| | Re: Reshaping 4.5v track
|
|
(...) You might want to check out Ross Neal's 3 stud wide solution... (URL) post pictures if you make something work. Benn (16 years ago, 24-Dec-08, to lugnet.trains)
|
| |
| | Re: Hopper car model
|
|
(...) You can also post it to the RailBricks gallery. Russell (16 years ago, 23-Dec-08, to lugnet.trains, FTX)
|
| |
| | Re: Hopper car model
|
|
(...) In addition to the places you mentions, the (URL) site allows you to set up a gallery. There's a lot of cross-over between forums, but that site is also beginning to pick up some users who are new to the hobby. -Elroy (who'll probably build a (...) (16 years ago, 23-Dec-08, to lugnet.trains, FTX)
|
| |
| | Re: Reshaping 4.5v track
|
|
(...) I’ve had some success using a heat gun although you have to monitor the temperature extremely closely. You could also try making small cuts on the inside of the curve rails, but i've never tried this method myself. ondrew (16 years ago, 23-Dec-08, to lugnet.trains)
|
