| | Re: 7-Wide BNSF & TTX Intermodal Train & Crane
|
|
(...) Another side topic I have not noticed to be mentioned here in Lugnet is the following: (URL) These new wheels (as shown by Heiner Berg from his 7898 set) have no bore hole reaching through the wheel, but they have a plastic tip which will be (...) (18 years ago, 28-Jun-06, to lugnet.trains, FTX)
|
|
| | Re: 7-Wide BNSF & TTX Intermodal Train & Crane
|
|
PS. And we're both ignoring the IR battery box in the centre which also has to be worked around. (18 years ago, 28-Jun-06, to lugnet.trains)
|
|
| | Re: 7-Wide BNSF & TTX Intermodal Train & Crane
|
|
(...) Hi David, I've actually tried something similar to that before but didn't like the studs. The other problem with it is that it may not work since real studs are a little taller than half a plate. The best I've come up with so far is something (...) (18 years ago, 28-Jun-06, to lugnet.trains)
|
|
| | Re: 7-Wide BNSF & TTX Intermodal Train & Crane
|
|
(...) Tim, Here is an idea I just put together. It uses many of the 1x2-2x2 Brackets. (URL) guess the only downside is that you have studs running the length of the train. Then again it does give it a nice textured look. (URL) (18 years ago, 28-Jun-06, to lugnet.trains, FTX)
|
|
| | Re: 7-Wide BNSF & TTX Intermodal Train & Crane
|
|
--SNIP-- (...) I think there's more to worry about than the weight. I've not been able to figure out any decent way of getting a seven wide shell over the six wide baseplate that IR requires. I've tried covering it with snotted panels, tiles and (...) (18 years ago, 28-Jun-06, to lugnet.trains, FTX)
|