Subject:
|
Re: BBB Train Hand Car
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Tue, 30 Aug 2005 15:18:22 GMT
|
Viewed:
|
6178 times
|
| |
|
|
In lugnet.trains, Dean Earley wrote:
> > The design is not LEGO pure. The model requires NBA/Basketball minifig legs
> > (with the springs removed) and a 1x4 technic thin lift arm (I cut the end off a
> > 1x5 technic thin liftarm. You can use 4263
> > <<http://www.bigbenbricks.com/ideabook/4263.jpg>> but the studs on the side
> > will bind occasionaly.
> >
> > I've tried lots of things to eliminate the 1x4 technic thin liftarm, but nothing
> > seems to work as well. Any suggestions are welcome.
>
> At a guess, you need the arm to be central in a 1 stud width of axle.
> A technique used by someone else (Mark Bellis I think) is to get a half
> smooth technic bush (4265c) and cut it in half (length ways). This will
> help keep the bar centred.
Thanks Dean! I don't know why I didn't try this before. I used a full with
bush and in conjunction with 4263 and it works very smooth.
I'll update the instructions to use the new configuration.
Ben
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: BBB Train Hand Car
|
| (...) At a guess, you need the arm to be central in a 1 stud width of axle. A technique used by someone else (Mark Bellis I think) is to get a half smooth technic bush (4265c) and cut it in half (length ways). This will help keep the bar centred. (21 years ago, 29-Aug-05, to lugnet.trains)
|
6 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
