|
|
 | | Re: best way to support elevated plates?
|
| (...) I will say that, although we still have 4 modules with this kind of construction that we will keep together for the forseeable future, we have abandoned that building style. Those GMLTC-style modules of ours are/were 30" x 45" (2X3 large gray (...) (19 years ago, 12-May-05, to lugnet.trains, FTX)
| | | | | Re: best way to support elevated plates?
|
| Thanks to both, that's very interesting. It's much denser than I had in mind; and though 2x2 and 2x4 bricks are dirt cheap, it would use a LOT of them. I'm not sure if it would actually come out cheaper or not, but it's certainly worth considering. (...) (19 years ago, 12-May-05, to lugnet.trains, FTX)
| | | | | Re: best way to support elevated plates?
|
| (...) And check out (URL) pic> and (URL) pic> to see that method in action. Ironically, we just completely cannibalized that module last week... Wanna buy some 2x2 towers? :-) JOHN (19 years ago, 12-May-05, to lugnet.trains, FTX)
| | | | | Re: 8 Wide LEGO Thomas! (pics)
|
| (...) Yes, well, I was once young as well, but never even heard a, well, peep about Thomas the Tank Engine until the PBS series "Shining Times Station" which began airing in the US in 1989. It is that series which propelled Thomas onto the world (...) (19 years ago, 12-May-05, to lugnet.trains, lugnet.duplo, FTX)
| | | | | Re: best way to support elevated plates?
|
| (...) Sorry for the bum steer. (it was under honeycomb not lattice, my bad) Try this post: (URL) which leads you to this pic: (URL) should set you right. (19 years ago, 12-May-05, to lugnet.trains)
|
|
