To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.trainsOpen lugnet.trains in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Trains / 24579
24578  |  24580
Subject: 
Re: clip on train motor
Newsgroups: 
lugnet.trains
Date: 
Fri, 11 Mar 2005 06:15:35 GMT
Viewed: 
1780 times
  
In lugnet.trains, Mitchell Lichtenberg wrote:
   This train newbie discovered that one of the four “L” shaped clips on a train motor has broken off. (There are two forward and two aft) Is this critical? How is this clip used? (I still have the clip, and possibly could glue it back on but I am not going to bother if I don’t really need to.) Thanks.

Hello Mitchell,

The tabs can be used to add on to the length of the train motor body by placing one edge of a 4-wide plate on them. The tab clips under the side edge of the plate. LEGO used this in some of their train designs. See the following example instructions from the 4559 set.(Not a great example but the first one I found a link for.)

http://library.brickshelf.com/gallery/set/4000/4559-1/4559-1-02.jpg

and

http://library.brickshelf.com/gallery/set/4000/4559-1/4559-1-03.jpg


As for gluing the tab back on, I have never tried it so I don’t know how feasible it is. Many train designs do not use them.

Good luck in any case! Hope this information helps!

Ciao!

DD



Message has 2 Replies:
  Re: clip on train motor
 
(...) Thats interesting, I never realised they were for that (not having ever bought a 9V set). I always thought they just got in the way! Tim (20 years ago, 11-Mar-05, to lugnet.trains, FTX)
  Re: clip on train motor
 
(...) The also help secure the buffer/coupler unit to the end of the motor. Without the clips, the buffer plate tends to lift off. But one clip should work OK for this. I doubt you'll be able to glue it with any viable strength. I have a couple of (...) (20 years ago, 11-Mar-05, to lugnet.trains, FTX)

Message is in Reply To:
  clip on train motor
 
This train newbie discovered that one of the four "L" shaped clips on a train motor has broken off. (There are two forward and two aft) Is this critical? How is this clip used? (I still have the clip, and possibly could glue it back on but I am not (...) (20 years ago, 11-Mar-05, to lugnet.trains)

6 Messages in This Thread:



Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR