 | | Re: Train Bases
|
|
(...) You have to be careful using the train base holes with vehicles longer than one base, since the bogie centres distance becomes so large that a motor (4x6 plate size) cannot turn far enough inside the train base on curves, so the vehicle (...) (20 years ago, 8-Feb-05, to lugnet.trains)
|
| |
| | Re: New MOC - fright car from the middle of the last century
|
|
It won't be long until these "digger buckets" are not longer needed! Check out the inital concept for this VO1000 switcher (Yet another Turtle Creek MOC)... (2 URLs) The roof is made up of the new 1x3 rounded bricks (LDRaw #50950) that is used as (...) (20 years ago, 8-Feb-05, to lugnet.trains, FTX)
|
| |
| | Re: New MOC - fright car from the middle of the last century
|
|
(...) Hi Larry, they are not really rare and appear now and then on Bricklink in amount of dozens. And these are just the black ones. The grey ones are often much more expensive at bricklink and other market places. I was lucky enough to get nearly (...) (20 years ago, 8-Feb-05, to lugnet.trains)
|
| |
| | Re: New MOC - fright car from the middle of the last century
|
|
(...) I dunno. *I* think the most difficult part of building one of these is saving up digger buckets till you have enough for a roof! Nice build. Spotlighted. Thanks for sharing! XFUT trains... (20 years ago, 8-Feb-05, to lugnet.loc.de, lugnet.build.schleim, lugnet.trains)
|
| |
| | Re: Packing the Mountain
|
|
(...) Mark, The lowest section of the support column is 2x4 duplo bricks. The middle column progresses to 2x8 LEGO brick configuration as it climbs up the back of the module. I do use 1x's on the cross members but all the main support columns never (...) (20 years ago, 8-Feb-05, to lugnet.trains)
|
