Subject:
|
Re: Steam locomotive drive assembly
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Tue, 16 Nov 2004 23:08:16 GMT
|
Viewed:
|
4846 times
|
| |
|
|
In lugnet.trains, Stacy Bledsoe wrote:
> In lugnet.trains, Lester Witter wrote:
> > In lugnet.trains, Stacy Bledsoe wrote:
> > >
> > > > > > http://www.brickshelf.com/cgi-bin/gallery.cgi?i=971547
> > > > >
> > > > > Very nice Stacy! I especially like how you used the frypan part as the valve end
> > > > > cover.
> > > > >
> > > > > ROSCO
>
> Thanks for your interest Lester, I have posted the link to the ldraw file below.
> There is one piece that is not shown on the valve block where the pushrod
> enters. It is a technic piece, 1x2 liftarm, like part#32523 but with two holes.
> It acts as a guide for the push rod/slider, and attached to the stud of the
> macoroni brick. Have fun building...
>
> http://www.brickshelf.com/cgi-bin/gallery.cgi?f=103770
Hi Stacy, thanks for that! And you can download the unofficial version of that
liftarm from here:
http://www.ldraw.org/cgi-bin/ptdetail.cgi?f=parts/43857.dat
HTH
ROSCO
|
|
Message is in Reply To:
 | | Re: Steam locomotive drive assembly
|
| (...) Thanks for your interest Lester, I have posted the link to the ldraw file below. There is one piece that is not shown on the valve block where the pushrod enters. It is a technic piece, 1x2 liftarm, like part#32523 but with two holes. It acts (...) (22 years ago, 16-Nov-04, to lugnet.trains)
|
9 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
