Subject:
|
Re: Steam locomotive drive assembly
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Tue, 16 Nov 2004 16:58:02 GMT
|
Viewed:
|
2059 times
|
| |
|
|
In lugnet.trains, Lester Witter wrote:
> In lugnet.trains, Stacy Bledsoe wrote:
> >
> > > > > http://www.brickshelf.com/cgi-bin/gallery.cgi?i=971547
> > > >
> > > > Very nice Stacy! I especially like how you used the frypan part as the valve end
> > > > cover.
> > > >
> > > > ROSCO
Thanks for your interest Lester, I have posted the link to the ldraw file below.
There is one piece that is not shown on the valve block where the pushrod
enters. It is a technic piece, 1x2 liftarm, like part#32523 but with two holes.
It acts as a guide for the push rod/slider, and attached to the stud of the
macoroni brick. Have fun building...
http://www.brickshelf.com/cgi-bin/gallery.cgi?f=103770
Stacy
*all creations copyright, not to be used in merchandised kits unless authorized
by Stacy Bledsoe.
|
|
Message has 1 Reply:
Message is in Reply To:
9 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
