Subject:
|
Re: Advice wanted
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Tue, 6 Jan 2004 13:49:05 GMT
|
Reply-To:
|
cjmasi@*nogarbageplease*SPAMLESSrcn.com
|
Viewed:
|
2619 times
|
| |
|
|
Tim David wrote:
> I want to put some boiler stays in, as below¬
> ¬
> <<http://www.brickshelf.com/gallery/talltim/Extras/baldwinbit.jpg>> ¬
> ¬
> However the front footplate moves in comparison to the boiler (to go round Lego
> corners/curves) meaning they need movement.¬ There three options I can think
> of:¬ 1 mount a rigid rod on a turntable at the lower end and don't fix the
> top end, just let it move in the gap between the boiler and tank (1/2 stud wide
> btw)¬ 2 mount a flexible rod (pneumatic tube) rigidly at the lower end and
> wedged in the gap between boiler and tank.¬ 3 mount the bar rigidly a the top
> and and not fixed at the bottom end so it just slides over the footplate (with
> the addition of some tiles)
>
> Does anyone have any thoughts or other suggestions?
>
> Tim
>
> PS I just noticed that one of the steps on the front of the tanks seem to have a
> black element and a grey element in the same place
Have you tried fixing the plate to the boiler and allowing a second
plate with tiles on top and the wheelset on bottom to slide beneath the
boiler?
Chris
|
|
Message is in Reply To:
 | | Advice wanted
|
| I want to put some boiler stays in, as below (URL) However the front footplate moves in comparison to the boiler (to go round Lego corners/curves) meaning they need movement. There three options I can think of: 1 mount a rigid rod on a turntable at (...) (23 years ago, 5-Jan-04, to lugnet.trains, FTX)
|
6 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
