Subject:
|
Re: Roller Doors into a Baggage Car
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Wed, 16 Jul 2003 14:35:25 GMT
|
Viewed:
|
1076 times
|
| |
|
|
In lugnet.trains, Jason Spears wrote:
| |
In lugnet.trains, James Mathis wrote:
| |
Here is a potential method of inserting
roller doors into a
baggage car.
For some time I have wanted to get the town garage roller doors into a
baggage car. I do realize that the proposed configuration linked to below
would not roll up all the way, but I think it is the closest I’ve come so
far in realizing an OK method of positioning the roller doors near to the
outer wall of the baggage car.
|
Impressive. You mentioned they don’t roll up all the way... How far do they
roll up?
|
I haven’t real-brick-built this design. I’m not sure how far they might roll
up-- maybe only a couple of bricks height? At most only half the height of the
rolling doors if one where to allow the top part of the door to roll down on the
back-side of the rubber wheel. I’ve tried to keep the upper part of the roller
door under the roof-line during roll-up by using a centered tile-beam, but I’m
not sure if that works or not.
Thanks for the reply.
later,
James Mathis
|
|
Message is in Reply To:
8 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
