Subject:
|
Re: Orientation of single train buffers
|
Newsgroups:
|
lugnet.cad, lugnet.trains
|
Date:
|
Tue, 17 Jun 2003 11:43:54 GMT
|
Viewed:
|
280 times
|
| |
|
|
In lugnet.cad, Niels Karsdorp wrote:
| |
I am about to create the single train buffers into LDraw.
What orientation shall I use, e.g. where to put the buffer:
* -X (left)
* +X (right)
* -Z (front)
* +Z (rear)
|
Hello Niels,
The buffer plate (the part that comes in contact with the buffer of another
wagon) should pont towards the -Z direction, because this is consistent with
existing official part #4022 Train Buffer Beam (see picture):
| |
I thought about putting the origin between the two studs.
|
I agree.
With friendly greetings, M. Moolhuysen.
|
|
Message is in Reply To:
 | | Orientation of single train buffers
|
| I am about to create the single train buffers into LDraw. What orientation shall I use, e.g. where to put the buffer: * -X (left) * +X (right) * -Z (front) * +Z (rear) I thought about putting the origin between the two studs. Niels (21 years ago, 17-Jun-03, to lugnet.cad, lugnet.trains)
|
5 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
