Subject:
|
Orientation of single train buffers
|
Newsgroups:
|
lugnet.cad, lugnet.trains
|
Date:
|
Tue, 17 Jun 2003 08:34:24 GMT
|
Viewed:
|
861 times
|
| |
|
|
I am about to create the single train buffers into LDraw.
What orientation shall I use, e.g. where to put the buffer:
* -X (left)
* +X (right)
* -Z (front)
* +Z (rear)
I thought about putting the origin between the two studs.
Niels
|
|
Message has 2 Replies:
 | | Re: Orientation of single train buffers
|
| (...) Hello Niels, The buffer plate (the part that comes in contact with the buffer of another wagon) should pont towards the -Z direction, because this is consistent with existing official part #4022 Train Buffer Beam (see picture): [LDrawPart (...) (21 years ago, 17-Jun-03, to lugnet.cad, lugnet.trains, FTX)
|
5 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
