Subject:
|
Re: Motorized Switch Point
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Fri, 24 May 2002 17:46:32 GMT
|
Viewed:
|
514 times
|
| |
|
|
In lugnet.trains, Thomas Mitchell writes:
> Hi all,
>
> I am working on a motorized switch point for my father in law. I saw the
> thread that's still around from a few years ago, but a lot of the links are
> broken. Does anyone have a motorized switch point which works fairly well?
>
> Tom
Lots of threads on this have came and went.
My most recent version is:
http://www.brickshelf.com/gallery/ejmcglynn/recipmotor/update-03-27-02/pointmotor.mpd
It works off of 0-9v power, any polarity, and signals it's position visually.
Ed
|
|
Message has 2 Replies:
 | | Re: Motorized Switch Point
|
| (...) Ed, Yep I have the file already. Was having some problems with MLCad, but I finally got things working. I'll give it a try. Tom (22 years ago, 25-May-02, to lugnet.trains)
| | | Re: Motorized Switch Point
|
| (...) Ed, I've been looking for the Technic Engine Crankshaft (2853) part. Do you recall where you found this piece? I've searched lugnet and all the kits it says the part is in doesn't contain the part. I need a total of six and would like to get (...) (22 years ago, 26-May-02, to lugnet.trains)
|
Message is in Reply To:
| | Motorized Switch Point
|
| Hi all, I am working on a motorized switch point for my father in law. I saw the thread that's still around from a few years ago, but a lot of the links are broken. Does anyone have a motorized switch point which works fairly well? Tom (23 years ago, 24-May-02, to lugnet.trains)
|
7 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
