Subject:
|
Re: Automatic train switching with RCX
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Tue, 15 Jan 2002 16:54:32 GMT
|
Viewed:
|
1210 times
|
| |
|
|
In lugnet.trains, Jason J. Railton wrote:
> > In lugnet.trains, Jason J Railton wrote:
> > > At some point I'll have to render my point motors though. I use an extra
> > > axle with a bush behind the drive pinion, to keep the rack level and stop
> > > the structure from lifting. I also use elastic bands as a belt drive for
> > > over-run protection - personally I think it's a much safer design. Does the
> > > latest part update for LDraw have some decent gears in it yet?
>
> In lugnet.trains, Steve Bliss writes:
> > How do you mean 'decent gears'? Are there some specific gears missing,
> > or are you having problems with the existing parts?
>
> Okay, this is phhhreaking me out. I just checked on my MLCAD and all the
> gear parts are there - and I haven't downloaded an update lately. The only
> thing I can think of is I stuck an extra 32MB memory in a few weeks ago.
It's possible you needed to do a 'parts scan' in MLCAD, to see all the
available parts.
> Beforehand, all I got were the outer teeth of the few gears that did appear.
> Or was I looking in the wrong section?
Did you get a new version of MLCAD, or change any of the settings? It's
been pointed out to me that some of the gears don't render well in
MLCAD. I believe that has to do with some of the rendering settings.
Steve
|
|
Message is in Reply To:
 | | Re: Automatic train switching with RCX
|
| (...) Okay, this is phhhreaking me out. I just checked on my MLCAD and all the gear parts are there - and I haven't downloaded an update lately. The only thing I can think of is I stuck an extra 32MB memory in a few weeks ago. Beforehand, all I got (...) (23 years ago, 14-Jan-02, to lugnet.trains)
|
5 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
