Subject:
|
Re: Automatic train switching with RCX
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Mon, 14 Jan 2002 22:47:41 GMT
|
Viewed:
|
701 times
|
| |
|
|
> In lugnet.trains, Jason J Railton wrote:
> > At some point I'll have to render my point motors though. I use an extra
> > axle with a bush behind the drive pinion, to keep the rack level and stop
> > the structure from lifting. I also use elastic bands as a belt drive for
> > over-run protection - personally I think it's a much safer design. Does the
> > latest part update for LDraw have some decent gears in it yet?
In lugnet.trains, Steve Bliss writes:
> How do you mean 'decent gears'? Are there some specific gears missing,
> or are you having problems with the existing parts?
Okay, this is phhhreaking me out. I just checked on my MLCAD and all the
gear parts are there - and I haven't downloaded an update lately. The only
thing I can think of is I stuck an extra 32MB memory in a few weeks ago.
Beforehand, all I got were the outer teeth of the few gears that did appear.
Or was I looking in the wrong section?
Jason J Railton
|
|
Message has 1 Reply:
 | | Re: Automatic train switching with RCX
|
| (...) It's possible you needed to do a 'parts scan' in MLCAD, to see all the available parts. (...) Did you get a new version of MLCAD, or change any of the settings? It's been pointed out to me that some of the gears don't render well in MLCAD. I (...) (23 years ago, 15-Jan-02, to lugnet.trains)
|
Message is in Reply To:
5 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
