 | | RCX motor pulsing —Steven Barile
|
| | | Since you guys are talking about this I have a question. I've asked it before and there was no responce. Here it goes: I want to use the RCX to control a single train thru the rails by providing "pulsed" voltage to have fine control over the trains (...) (24 years ago, 18-May-01, to lugnet.trains, lugnet.robotics)
|
| | | |
| | | | | Re: RCX motor pulsing —Stef Mientki
|
| | | | | What kind of train you to use (Lego, Trix, other) ? Although I've no experience, I have the feeling that only a Lego train could be controlled, as far as I know Trix uses AC current and for the other brands I've the feeling all specs are too low. (...) (24 years ago, 19-May-01, to lugnet.trains, lugnet.robotics)
|
| | | | | |
| | | | | Re: RCX motor pulsing —Sonnich Jensen
|
| | | | | I don't use the RCX but I do know know to control a motor. I would picup the power and "pulse" the motor will e.g. 400 Hz, but pulse-wide-modulated. The idea is that the motor gets full power but not all the time meaning thar it has full strenght (...) (24 years ago, 19-May-01, to lugnet.trains, lugnet.robotics)
|
| | | | | |
| | | | | | | Re: RCX motor pulsing —Bernardo Dal Seno
|
| | | | | | (...) The good news is that the RCX outputs are pulse-width modulated. bye Bernardo New e-mail: dibbe@freestation.it (24 years ago, 19-May-01, to lugnet.trains, lugnet.robotics)
|
| | | | | | |
| | | | | | | | Re: RCX motor pulsing —Steven Barile
|
| | | | | | I have controlled LEGO trains via the RCX many times. The question is how to control the speed of the train under a finer ganularity then just the native power levels. snip ...this comment has promise! Can you vary the width of the pulse? <The good (...) (24 years ago, 22-May-01, to lugnet.trains, lugnet.robotics)
|
| | | | | | |
| | | | | | | | Re: RCX motor pulsing —Bernardo Dal Seno
|
| | | | | | (...) Yes. When you set the power for an output port actually you select the duty cycle of a square wave. The granularity depends on firwmare. With standard firmware you can select between 7 power levels; legOS has 255 levels. bye Bernardo New (...) (24 years ago, 22-May-01, to lugnet.trains, lugnet.robotics)
|
| | | | | | |
| | | | | Re: RCX motor pulsing —Zhengrong Zang
|
| | | | I have been using RCXs to control tracks, you also can control signal in the (...) (23 years ago, 28-May-01, to lugnet.trains, lugnet.robotics)
|
| | | | |
