 | | Re: Proposed 'Legomodule' standard
|
|
I was under the impression that you were using 3/4" plywood, which is what I was told before. I am using 3/4" plywood on top of the banquet legs. I will check the height this evening and post it. FYI, 20 bricks + 1 plate + 1 baseplate = 7.748", so (...) (25 years ago, 24-Mar-00, to lugnet.trains)
|
| |
| | Re: Proposed 'Legomodule' standard
|
|
(...) I'm not even certain. I think the banquet table legs are around 30 inches, 1/2 inch plywood, 20 bricks = track height around 36 or 38 inches... (I might be way off though...) JohnG, GMLTC (25 years ago, 23-Mar-00, to lugnet.trains)
|
| |
| | Re: Proposed 'Legomodule' standard
|
|
(...) This is fine. Have you considered...lowering the scenery and keeping the track at the same level? However, I would tend to think that it would work either way...and 10 bricks high is buildable by more people than 20 (about 2/3 bricks as a (...) (25 years ago, 23-Mar-00, to lugnet.trains)
|
| |
| | Proposed 'Legomodule' standard
|
|
Larry P and I have been overloading my email server going back and forth on this topic today. This is what I'm proposing: TWO standards. A 'LOW' standard, and a 'HIGH' standard. Low standard is 10 bricks tall, High standard is 20 bricks tall. We'd (...) (25 years ago, 23-Mar-00, to lugnet.trains)
|
| |
| | Re: Lego Modular tables
|
|
Good start. I've found the locations of set track alignments to be a tricky one. Since LEGO track doesn't (yet) come in differnent lengths, does your proposed standard presume the track ends right at the end of the module, or perhaps 8 studs from (...) (25 years ago, 23-Mar-00, to lugnet.trains)
|
