 | | Re: Lubricating axels, etc.
|
|
(...) <try a ramp, here's how> Excellent advice. If after proper weighting, you are still struggling to get things moving, there is a problem. Ben's test is good. Also examine individual wheelsets. If you flick a wheel with your thumb, it should (...) (23 years ago, 1-Aug-01, to lugnet.trains)
|
| |
| | Re: Train Weight Question
|
|
(...) okay, thanks guys. (23 years ago, 1-Aug-01, to lugnet.trains)
|
| |
| | Re: Legoland Train Show Aug 4 and 5 (and 6th?)
|
|
(...) I think the article itself mentions that this was a PNLTC event to set a Guinness world record... (23 years ago, 1-Aug-01, to lugnet.trains)
|
| |
| | Re: what is the use of a caboose?
|
|
Hi a;;, Since I started this thread (about 3 years ago, he he) I bought and recieved the caboose. It's nice! Only thing to yap about is that the elevated section, which is closed at the bottom with a 4 x 6 plate... Could have done better/different (...) (23 years ago, 1-Aug-01, to lugnet.trains)
|
| |
| | Re: Lubricating axels, etc.
|
|
(...) under (...) Thanks Larry, the direct back-translation of needle bearing would be "Nadellager" in German, but Nadellager has a completely different meaning here. That is a roller bearing with very fine (long and thin like needles) cylinders (...) (23 years ago, 1-Aug-01, to lugnet.trains)
|
| |
| | Re: Train Weight Question
|
|
(...) I find better performance if I add weight, even to 9V motors. Or at least design my models so that there is more of the weight over the powered truck than the unpowered one... (23 years ago, 1-Aug-01, to lugnet.trains)
|
| |
| | Re: what is the use of a caboose?
|
|
(...) Actually, flywheel is perfectly practical. Sentinel (once again!) made a loco that was powered by, IIRC, 2 2 ton flywheels, and it was reasonably capable (but expensive). I tend to think that a flywheel drive system is more practical for bus (...) (23 years ago, 1-Aug-01, to lugnet.trains)
|
| |
| | Re: Train Weight Question
|
|
(...) Train weights are used to keep a train on track. The problem is in curves, where it might derail. The weight will pull the train down and keep it on the track. Lego had their weight over the wheels, but I find it is better to have them next to (...) (23 years ago, 1-Aug-01, to lugnet.trains)
|
| |
| | Re: what is the use of a caboose?
|
|
In lugnet.trains, Simon Bennett writes: <snip some very interesting info> Good info on the reasons why monorails just aren't that practical. The example people always trot out about the Wuppertalbahn kind of highlights the right of way issues! It (...) (23 years ago, 1-Aug-01, to lugnet.trains)
|
| |
| | Re: Lubricating axels, etc.
|
|
(...) "needle" bearings. That is, they are just a hard metal point in a soft metal (or in this case, hard plastic) cup. Very common in regular MR as well where the metal is often Stainless Steel and the plastic is Delrin, a hard kind of nylon I (...) (23 years ago, 1-Aug-01, to lugnet.trains)
|
