 | | Re: My first MOC locomotive
|
|
(...) Hey, i was thinking or making a F45 too, but i decided apon a simalar locomotive, the SD40-2F, built for the Canadian Pacific Railway. Here are some pictures, i liked the distinctive wedge (has a special name, can't think of it now): (URL) (...) (24 years ago, 13-Mar-01, to lugnet.trains)
|
| |
| | Re: My first MOC locomotive
|
|
(...) Thank you very much! After doing a few shows with PNLTC, I've seen a lot of really nice MOC trains in the last 6 months. Being around these guys has to rub off at least a little. (...) When I was building this, I only had 2 pictures to go on (...) (24 years ago, 12-Mar-01, to lugnet.trains)
|
| |
| | Re: My first MOC locomotive
|
|
(...) A *very nice* first MOC! (much better than my first attempts!) I like the use of the fence pieces on the sides to represent venting. One question on the 'tail end', since I'm not familiar with this locomotive. Should there be a door of some (...) (24 years ago, 12-Mar-01, to lugnet.trains)
|
| |
| | My first MOC locomotive
|
|
Hello, all- This is my first true MOC locomotive- in the past, I've only worked with 4.5 volt trains. And the 4.5 volt locomotives I made were just slightly modified official sets. I did this up in my LTC's colors, and added a few stickers to pretty (...) (24 years ago, 12-Mar-01, to lugnet.trains) !
|
| |
| | Re: Pics of my "Auto Hopper" unloading hopper car
|
|
(...) Yes, the unloading is happening over 4.5 volt track so that I can discharge into a bin below. Also I'm working on making the same section of track act as a scale by using some springs and a rotation sensor. As for the how the RCX will interact (...) (24 years ago, 12-Mar-01, to lugnet.trains)
|
