| |
On 2/12/08, mahjqa <mahjqa@gmail.com> wrote:
> > I'm curious about the drive wheels for the tractor. It appears you're
> > using wheels with pin holes, not cross-axle holes. Is that correct,
> > or did you swap out the wheels for different pictures?
>
> I see you're paying close attention! I was set on using the chromed
> <http://peeron.com/inv/parts/55981 rims> that were used in some versions of
> <http://peeron.com/inv/sets/4883-1 4883 Gear Grinders>. And sadly, those chromed
> ones don't have axleholes...
Yes, I really like those wheels, also.
> Luckily, that can be circumvented. Earlier, when rebuilding the Batmobile to
> include a little mechanism I found out that a little part could solve my
> problem...
>
> <<http://www.brickshelf.com/gallery/mahjqa/ideas/batmobile1.jpg>>
>
> Two helpings of <<http://media.peeron.com/ldraw/images/71/32054.png>> and I was
> on my way again.
So, they are friction pins at least. And it gives the drive some
slip, to help it turn better. Very nice
Steve
|
|
Message is in Reply To:
 | | Re: Phoenix
|
| (...) I see you're paying close attention! I was set on using the chromed (URL) rims> that were used in some versions of (URL) 4883 Gear Grinders>. And sadly, those chromed ones don't have axleholes... Luckily, that can be circumvented. Earlier, (...) (19 years ago, 12-Feb-08, to lugnet.town, lugnet.technic, FTX)
|
11 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
