| |
| |
I’m curious about the drive wheels for the tractor. It appears you’re
using wheels with pin holes, not cross-axle holes. Is that correct,
or did you swap out the wheels for different pictures?
|
I see you’re paying close attention! I was set on using the chromed
rims that were used in some versions of
4883 Gear Grinders. And sadly, those chromed
ones don’t have axleholes...
Luckily, that can be circumvented. Earlier, when rebuilding the Batmobile to
include a little mechanism I found out that a little part could solve my
problem...
Two helpings of  and I was
on my way again.
|
|
Message has 1 Reply:
 | | Re: Phoenix
|
| (...) Yes, I really like those wheels, also. (...) So, they are friction pins at least. And it gives the drive some slip, to help it turn better. Very nice Steve (17 years ago, 12-Feb-08, to lugnet.town, lugnet.technic)
|
Message is in Reply To:
| | Re: Phoenix
|
| (...) Very nice. I'm curious about the drive wheels for the tractor. It appears you're using wheels with pin holes, not cross-axle holes. Is that correct, or did you swap out the wheels for different pictures? In any case, it's very nice. Steve (17 years ago, 12-Feb-08, to lugnet.town, lugnet.technic)
|
11 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
