Subject:
|
Re: Just an idea for an prop for a hovercraft
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Thu, 6 Feb 2003 07:30:10 GMT
|
Viewed:
|
664 times
|
| |
|
|
"Øyvind Steinnes" <senniets@online.no> wrote in message
news:H9us2z.K4r@lugnet.com...
<cut>
> http://www.brickshelf.com/gallery/Phoenix/Diverse/propell.jpg
> The only diffrence by this and my construction of the propeller is that • I've
> used the Technic Panel Fairing #20 (or #21 depending of the direction of
> rotation) instead of #3 /#4. They are a lot smoother and push more air.
>
> I've made an small hovercraft with the same principle as Paul's hovercraft
> but I only used a 9v battery pack to drive the old style 9v motor. And I • got
> lift! :)
good idea oyvind i'll show you my new fixed propellor soon
so probably it could be incorporated with your idea
i've got some questions
couldn't be better to use maclaren F1 panels?
how do you prevent tilting pannels in the oposite direction to air flow?
> Is the tunnel around the propell very important?
> Does it makes the propell push more air?
you know the duct gives the air right direction
and, which is very important, it gives "more" air
why quoted?
because if the duct (tunnel) is not heigh enough it didn't
you know when air is pressed under the hovercraft
it looks for escape
then when it escapes around the rotating blades
the rotor sucks it again
so the tunnel has to be heigh enough (by trials and errors :)))
it wouldn't be so importand if the machine could be stronger
but if it could be
it would be helicopter :)))
> There are probably some leaks of air around my construction. But I think • the
> prop can be turned about as fast as you want because no parts will deatach
> when spinning in high speed.
it is the best thing in your design
regards
pixel
|
|
Message has 1 Reply:
 | | Re: Just an idea for an prop for a hovercraft
|
| "pixel" <pixsrv@poczta.onet.pl> wrote in message news:H9vM7J.4ut@lugnet.com... (...) As I wrote I used the #20 / #21 panels. That is the panels that comes with the Williams F1, the other has a big hole in the midle and are too bulky. I testet both (...) (22 years ago, 6-Feb-03, to lugnet.technic)
|
Message is in Reply To:
| | Just an idea for an prop for a hovercraft
|
| Hello I've seen the marvelous creation of hovercrafts by Paul Kleniewski ( (URL) ) and that gave me some ideas. Here can you see a simpel construction of an propell that I made. I've not taken any photos yet, but here is one image made in Ldraw: (...) (22 years ago, 5-Feb-03, to lugnet.technic)
|
6 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
