| |
I need help in designing a motor-driven hammer for my RCX Tank Base Two.
The hammer should be forced down to create a greater impact than that as if
it were simply dropped. The hammer should have a length of about 28 studs
from its point of rotation to its head. Ideally the hammer should have a
range of motion of about 30 degrees to 180 degrees (at 30 degress the hammer
nicely stores on the robot base, at 180 degrees the hammer has been fully
released). The working mechanism should fit in an area of 8 by 14 studes or
6 by 24 studs (this depends on the position of the RCX). Minimal height is
desired, 5 to 6 bricks is expected.
In lugnet.technic, Steve Hassenplug writes:
> What problems are you having?
>
> In lugnet.technic, Roy Nelson writes:
> > Hello All,
> >
> > I'm looking for some mechanical design help.
> >
> > I am attempting to build a hammer device for my RCX Tank Base Two, kind of a
> > 'Robot Warriors' thing. I'm looking for ideas on how to do this, so far I
> > have failed at my own attemps.
> > If you have any ideas how to solve this problem please let me know.
> >
> > Roy Nelson
|
|
Message has 1 Reply:
 | | Re: Hammer Help
|
| winding and unwinding string seems to be to slow if i understand it good so my idea is here: use two wheels (pulleys) especiali as big as you can put into your design they should be with flat surface so it meand they should be from old sets like: (...) (22 years ago, 13-Dec-02, to lugnet.technic, lugnet.robotics)
|
Message is in Reply To:
5 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
