 | | Re: 120 degree connector —Thomas Avery
|
| | | (...) Hi Rob, It's going to be hard to connect beams at exactly 120 degrees. There aren't many pieces that have connections at that angle. I think the 3-arm rotors will work, as you suggested. The following link contains two quick ideas that I put (...) (23 years ago, 13-Jun-01, to lugnet.technic)
|
| | | |
| | | | | Re: 120 degree connector —Chris Phillips
|
| | | | (...) Couldn't you use an equilateral triangle to construct a 120-degree angle? Like the top picture that Thomas posted, but either Technic beam extends two holes past the point where the two beams pivot. Then a simple 3-hole 1/2-wide connector (...) (23 years ago, 13-Jun-01, to lugnet.technic)
|
| | | | |
| | | | | | Re: 120 degree connector —Thomas Avery
|
| | | | | (...) Yep, perfect sense. Try it again: (URL) J. (23 years ago, 13-Jun-01, to lugnet.technic)
|
| | | | | |
| | | | | | | Re: 120 degree connector —Chris Phillips
|
| | | | | | (...) Ahh, yes! That's _exactly_ what I was saying!!! Thanks for drawing this up! (23 years ago, 13-Jun-01, to lugnet.technic)
|
| | | | | | |
| | | | | | RE: 120 degree connector —Bram Lambrecht
|
| | | | (...) Here's another way to construct an equilateral triangle where you attach to the sides (120 degrees apart) (URL) can of course use hinge plates instead. If you attach technic plates, you could then attach technic beam holes to the technic plate (...) (23 years ago, 13-Jun-01, to lugnet.technic)
|
| | | | |
| | | | | | Re: 120 degree connector —Rob Stehlik
|
| | | | (...) Wow! I like this idea! I have tons of those hinge plates from the 8880 supercar. Rob (23 years ago, 14-Jun-01, to lugnet.technic)
|
| | | | |
