Subject:
|
Re: Dissecting a micromotor
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Sat, 10 Mar 2001 04:58:28 GMT
|
Viewed:
|
1296 times
|
| |
|
|
Thanks, Henry! The motor came apart like a charm. I even managed to get it
unjammed.
Jake
In lugnet.technic, Henry Chea writes:
> To get to the gears, you need to open up the micromotor from the other
> side, the round side.
>
> If you look at the black round part (the part that's supposed to spin
> around when powered), you will see a red ring around it. Use a thin
> knife to pry this red ring off, by prying the outside diameter of the
> red ring. Once you get the red ring off, the rest should come out quite
> easily, perhaps so easy that you'll lose parts if you're not careful.
>
> //Henry Chea
> hchea@kungstorget.nu
> *S* Göteborg, ja ja, jag behöver inget mer! *S*
> http://www.kungstorget.nu
|
|
Message is in Reply To:
 | | Re: Dissecting a micromotor
|
| To get to the gears, you need to open up the micromotor from the other side, the round side. If you look at the black round part (the part that's supposed to spin around when powered), you will see a red ring around it. Use a thin knife to pry this (...) (24 years ago, 10-Mar-01, to lugnet.technic)
|
4 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
