 | | Re: Any Ideas= 8448 and 4 wheel steering?
|
|
Similar to what I'm building now I think. I'm using 2 u-joints with 'parallelogram' suspension, and it works ok as long as you make sure that the pivot points for the hub and suspension are vertically aligned witht he u-joint pivot points. That way, (...) (24 years ago, 18-Jan-01, to lugnet.technic)
|
| |
| | Re: Any Ideas= 8448 and 4 wheel steering?
|
|
(...) dmensions. You also have to make sure the two u-joints are connected with the "slits" matching, not 90 degrees apart, or you'll get the sinusoidal variation Jason mentions here: (URL) you don't understand my description (you wouldn't be the (...) (24 years ago, 18-Jan-01, to lugnet.technic)
|
| |
| | Re: Any Ideas= 8448 and 4 wheel steering?
|
|
(...) Well, I did it for good looks, but now I'm glad i did! Whew. Not sure how long that wouldv'e taken me to figure out. I finally mounted my t-block engine and the two-speed auto tranny to the rear assembly. And darned if it dont all work! (...) (24 years ago, 19-Jan-01, to lugnet.technic)
|
| |
| | Re: Any Ideas= 8448 and 4 wheel steering?
|
|
I figured out 4WD/4WS two years ago :+) It also has a working differential so that when one wheel gets off the ground, the other will still get traction. Check it out: (URL) this model does not do, but could easily have, is a differential between (...) (24 years ago, 19-Jan-01, to lugnet.technic)
|
| |
| | Re: Any Ideas= 8448 and 4 wheel steering?
|
|
Mine has a transverse mounted 12 cyl engine, and a two speed worm gear tranny. The rear axle has a differential, but I have one problem. Using a worm gear in hte tranny means that the engine can drive the wheel, but during gear changes, the axle (...) (24 years ago, 19-Jan-01, to lugnet.technic)
|
| |
| | Re: Any Ideas= 8448 and 4 wheel steering?
|
|
(...) Looking forward to it 8?) ROSCO (24 years ago, 19-Jan-01, to lugnet.technic)
|
| |
| | Re: Any Ideas= 8448 and 4 wheel steering?
|
|
Now you tell me! oh well, I found a way too... I'll post a link to pictures when I'm done. Gary SuperD <dmf67@yahoo.com> wrote in message news:G7FHIt.CDL@lugnet.com... (...) (24 years ago, 20-Jan-01, to lugnet.technic)
|
