 | | Re: Four prop-plane engine (Was: Re: Another Technic Creation)
|
|
(...) (URL) also found these: (URL) A (...) (25 years ago, 27-Nov-00, to lugnet.technic)
|
| |
| | Four prop-plane engine (Was: Re: Another Technic Creation)
|
|
(...) Despite my above average interest in WWII planes I could not picture what the Lancaster looks like, so I went to www.airliners.net and searched, they have a couple of photos if anyone else has the same problem :) Here is a good view of the (...) (25 years ago, 27-Nov-00, to lugnet.technic)
|
| |
| | Re: Another Technic Creation
|
|
<<Snippely-snipp>> (...) ROFLMAO! (25 years ago, 27-Nov-00, to lugnet.technic)
|
| |
| | Re: Steerable Drive Axle
|
|
(...) What Znap set did they come with? (25 years ago, 27-Nov-00, to lugnet.technic)
|
| |
| | Re: Helicopter
|
|
(...) So... You're the one :) I've seen the pictures while checking the "Recent" stuff on Brickshelf a few times and I must say I loved reading some text and explanations to the pictures :) Good work! (25 years ago, 27-Nov-00, to lugnet.technic)
|
| |
| | Re: Adjustable 4 wheel steering
|
|
(...) No, it's not a single throttle. Throttle controls volume rate of flow for steam, valve gear controls cut off (position of piston to TDC when admission is stopped). Hackworth Valve Gear does not have a curved arm, perhaps take a look at it, (...) (25 years ago, 27-Nov-00, to lugnet.technic)
|
| |
| | Re: Another Technic Creation
|
|
(...) I'm not sure if I understand the meaning of what you write above. But if you intend to build a plane which can be moved from the power output of the propellers alone, then I think you may be in for a disappointment. I would be very surprised (...) (25 years ago, 26-Nov-00, to lugnet.technic)
|
| |
| | Re: Adjustable 4 wheel steering
|
|
I have had luck with an air selection system. Utilizing the 1.25" cylinders for engaging the axles from one steering setup to the other. This takes a lot of room as you have to run both pinion shafts to each axle and have a cylinder there to engage (...) (25 years ago, 27-Nov-00, to lugnet.technic)
|
| |
| | Re: 8880 Super Car information
|
|
(...) ok but where can I get the light grey and black? (25 years ago, 27-Nov-00, to lugnet.technic)
|
| |
| | Re: 8880 Super Car information
|
|
(...) You can see that the shock absorbers on 8448 are dark grey and black. Instead use the light grey and black - they are stronger. Eric. (25 years ago, 27-Nov-00, to lugnet.technic)
|
