 | | where can I get the mag wheel master???????
|
|
I live in canada and was wondering if there are any outlet stores or anything where I can get the mag wheel master. i recently bought the circuit shock racer off of my friend at school but I'm looking to start a website with technic MOC motorcycles (...) (25 years ago, 21-Nov-00, to lugnet.technic)
|
| |
| | Re: Another Technic Creation
|
|
(...) I came to exactly the same conclusion. I hope we are both correct! (...) A pure mechanical solution, which would work with 4 wheel steered vehicles, with each axle being steered to the same (or opposite) angle such as the one you describe, is (...) (25 years ago, 21-Nov-00, to lugnet.technic)
|
| |
| | Re: Another Technic Creation
|
|
Jennifer Clark wrote: [] (...) I've been toying with this -- mostly on paper -- as well, in attempt to convert my 8448 to four-wheel dual-mode steering. Unfortunately, as far as I can tell, the only way to do it its to only switch modes when the (...) (25 years ago, 20-Nov-00, to lugnet.technic)
|
| |
| | Re: Another Technic Creation
|
|
(...) a (...) better, (...) A _mere_ 9V? I ran one up to 54V, for short periods of time. However, the real answer is to use a hefty 12V motor. I have a 12V can motor (it might even be a 24V job, in fact) that runs quite happy with _anything_ you (...) (25 years ago, 20-Nov-00, to lugnet.technic)
|
| |
| | Re: Another Technic Creation
|
|
(...) I remember this too, and also remembering building the thing and wondering why they were closing off one of the gears - they did it with a 1x1 plate if I remember correctly? I think it was because the engine went amazingly fast in the lowest (...) (25 years ago, 20-Nov-00, to lugnet.technic)
|
