To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.technicOpen lugnet.technic in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Technic / 16024 (-5)
  Re: How to make a perfect octagon or hexagon?
 
(...) A 12-12-17 triangle is very nearly right, and has angles of about 44.9 degrees. I used four of them in making a stop sign: (URL) Note that all eight corners are nicely studded down. Joe and Brian wrote: (...) Well whaddaya know! I'd always (...) (17 years ago, 10-Dec-07, to lugnet.technic, lugnet.edu, FTX)
 
  Re: How to make a perfect octagon or hexagon?
 
(...) Try approaching it in steps. Can you make an equilateral triangle out of Technic beams? Don't worry about making the angles rigid, just make a structure with three equal-length sides, connected near the corners (connected with something that (...) (17 years ago, 10-Dec-07, to lugnet.technic)
 
  Re: How to make a perfect octagon or hexagon?
 
(...) The tri-blade is great for hexagons.... (URL) (17 years ago, 10-Dec-07, to lugnet.technic, FTX)
 
  Re: How to make a perfect octagon or hexagon?
 
(...) It would appear that they're approximately 126.8698976 degrees. That's from approximating some angles and noticing that what I think they were trying to do was to create the geometry such that a 3-4-5 right triangle was possible. DaveE (17 years ago, 10-Dec-07, to lugnet.technic, FTX)
 
  Re: How to make a perfect octagon or hexagon?
 
Your best bet would be the #4 angle connector, its a 135 degree angle. (17 years ago, 10-Dec-07, to lugnet.technic)


Next Page:  5 more | 10 more | 20 more

Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR