 | | Re: How to make a perfect octagon or hexagon?
|
|
(...) Try approaching it in steps. Can you make an equilateral triangle out of Technic beams? Don't worry about making the angles rigid, just make a structure with three equal-length sides, connected near the corners (connected with something that (...) (17 years ago, 10-Dec-07, to lugnet.technic)
|
| |
| | Re: How to make a perfect octagon or hexagon?
|
|
(...) The tri-blade is great for hexagons.... (URL) (17 years ago, 10-Dec-07, to lugnet.technic, FTX)
|
| |
| | Re: How to make a perfect octagon or hexagon?
|
|
(...) It would appear that they're approximately 126.8698976 degrees. That's from approximating some angles and noticing that what I think they were trying to do was to create the geometry such that a 3-4-5 right triangle was possible. DaveE (17 years ago, 10-Dec-07, to lugnet.technic, FTX)
|
| |
| | Re: How to make a perfect octagon or hexagon?
|
|
Your best bet would be the #4 angle connector, its a 135 degree angle. (17 years ago, 10-Dec-07, to lugnet.technic)
|
| |
| | How to make a perfect octagon or hexagon?
|
|
I'm trying to make a largish (20 cm across or so) octagon or hexagon out of technic parts. I thought this would be easy, because I believed that the bent technic beams (e.g. (URL) 32348>) had a 135-degree angle, or at least some angle that would (...) (17 years ago, 10-Dec-07, to lugnet.technic, FTX)
|
