 | | Re: System to allow pressure and vacuum for piston at the same time
|
|
(...) I think I may, if I have enough switches. I only have the contents of one of the new studless backhoes, minus one piston because I broke off the bottom port and can't figure out a way to repair it. Oh, and I also have the pneumatics from the (...) (19 years ago, 23-Nov-05, to lugnet.technic)
|
| |
| | Re: System to allow pressure and vacuum for piston at the same time
|
|
(...) Andrew, If you call LEGO customer service, they may replace your broken piston. Well a pressure/vacuum engine will run only on pressure. The vacuum parts would be exhaust pressure to the atmosphere. I did all my testing simply using pressure, (...) (19 years ago, 23-Nov-05, to lugnet.technic)
|
| |
| | Re: System to allow pressure and vacuum for piston at the same time
|
|
(...) Tricky? Difficult? Here are a few to get you started: (URL) Enjoy! You bet! CSSoh ...where air and/or vacuum is power ;-) (19 years ago, 23-Nov-05, to lugnet.technic)
|
| |
| | Re: System to allow pressure and vacuum for piston at the same time
|
|
(...) ;^) (19 years ago, 23-Nov-05, to lugnet.technic)
|
| |
| | Re: System to allow pressure and vacuum for piston at the same time
|
|
(...) Even though it was my own clumsiness that was at fault? (I sort of... fell on it, when it was part of a sailcar akin to Mario Ferrari's: (URL)) (...) I always like to start enormous threads ;-) I remember one that I started on .robotics in (...) (19 years ago, 24-Nov-05, to lugnet.technic)
|
| |
| | Re: System to allow pressure and vacuum for piston at the same time
|
|
(...) Yes. Even if you broke it due to clumsiness. Kev (19 years ago, 24-Nov-05, to lugnet.technic)
|
