| | Re: Technic question: how to connect 2 technic beams
|
|
(...) Thanks for the ideas... however I am constrained to a height of 2 beams. This height restriction is what is causing me grief as I can not space the beams or add above/below to use the liftarms. Jeff (19 years ago, 5-Oct-05, to lugnet.technic, FTX)
|
|
| | Re: Usage of hose 3mm diameter.
|
|
(...) I tried fitting a 3mm flexible hose into a normal hose, but without success! It might be possible but would take longer than fitting a 3mm rigid flex tube into a normal hose. The 3mm hose breaks easily if it is stretched over a 3mm flex tube - (...) (19 years ago, 5-Oct-05, to lugnet.technic)
|
|
| | Re: Technic question: how to connect 2 technic beams
|
|
(...) If you have no plates, put four bricks on top of each other between the beams and use a 7L liftarm rather than the 5L one pictured above. Mark (19 years ago, 5-Oct-05, to lugnet.technic, FTX)
|
|
| | Usage of hose 3mm diameter.
|
|
I'm wondering if this hose can be safely used in pneumatic switching circuits or if it's thin inside diameter would restrict airflow somewhat. I've got an idea where I might be tight on space around the valves, so I wondered to myself if 3mm hose is (...) (19 years ago, 5-Oct-05, to lugnet.technic)
|
|
| | Re: Technic question: how to connect 2 technic beams
|
|
(...) put the two [LDrawPart 3703] one on top of the other. On the middle of the top one put one [LDrawPart 3700], on it one [LDrawPart 3023] and on it one [LDrawPart 3700]. The hole in the top [LDrawPart 3700] can now be braced to the bottom beam (...) (19 years ago, 5-Oct-05, to lugnet.technic, FTX)
|